DNA/RNA Removal Reagent

Product Introduction

Nucleic acid detection technologies such as PCR/qPCR are widely used and have very high sensitivity. Once nucleic acid contamination occurs in the laboratory, it is easy to lead to false positive results and affect the accuracy of detection. The extraction of nucleic acid in the sample processing stage and the leakage of amplified products in the detection stage will lead to nucleic acid pollution. The spattered amplified products will form aerosols floating in the air, adhere to the surface of objects and the body of detection personnel, and pollute the entire laboratory with the flow of personnel and materials. Once nucleic acid contamination occurs in the laboratory, it is difficult to remove, which will cause the laboratory to be unable to carry out work in the short term, so preventing and removing nucleic acid contamination is the focus of molecular detection laboratories.

This product can effectively degrade nucleic acid molecules, prevent aerosol pollution, easy to use, the effect is obvious, can remove the DNA and RNA pollution on the surface of laboratory instruments and operating sites; Can be used to clean electrophoresis equipment, pipette, centrifugal tube, centrifugal column and other devices; Simple and fast, spray design, spray use; It only takes 5 minutes, after spraying and wiping.

How to use

1. Clean the laboratory table: spray it directly and wipe the table with clean paper towels or alcohol wipes after about 5 minutes to create an experimental environment free of RNA enzymes and nucleic acid templates.

2. Laboratory equipment cleaning: wet the paper towel and wipe the surface of the equipment, and then dry with a clean paper towel; For small equipment, dry directly after soaking.

3. Plastic glass equipment: Soak the experimental consumables in this product for 5-10 min, rinse with sterile water and air dry.

4. Pipette cleaning: After disassembling the pipette according to the instructions, soak the components easily contaminated with nucleic acid in the product for 5min, rinse with sterile water and air dry.

5. Nucleic acid aerosol cleaning: When there is mild nucleic acid aerosol pollution in the laboratory, this product can be used to spray the laboratory comprehensively, and wait for about 1 h. When the nucleic acid aerosol pollution in the laboratory is more serious, it is recommended to treat 2-3 times, the effect is better.

Note:

1. The product is limited to scientific experimental research and shall not be used in clinical diagnosis, treatment and other fields;

2. This product is for nucleic acid removal of PCR laboratory instruments, consumables and environmental aerosols, and cannot be directly added to the PCR amplification system;

Remark：These protocols are for reference only. Solarbio does not independently validate these methods.

Note：

1. The products are all for scientific research use only. Do not use it for medical, clinical diagnosis or treatment, food and cosmetics, etc. Do not store them in ordinary residential areas.

2. For your safety and health, please wear laboratory clothes, disposable gloves and masks.

3. The experimental results may be affected by many factors, after-sale service is limited to the product itself and does not involve other compensation.